Removal [06/2015 - ]: Procedure
- REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
Refer to PROCEDURE - Step 4 [06/2015 - 11/2018] , or refer to PROCEDURE - Step 4 [11/2018 - ]
- REMOVE FRONT DOOR ARMREST COVER
Refer to PROCEDURE - Step 5 [06/2015 - 11/2018] , or refer to PROCEDURE - Step 5 [11/2018 - ]
- REMOVE NO. 1 FRONT DOOR STIFFENER CUSHION
Refer to PROCEDURE - Step 6 [06/2015 - 11/2018] , or refer to PROCEDURE - Step 6 [11/2018 - ]
- REMOVE COURTESY LIGHT ASSEMBLY
Refer to PROCEDURE - Step 1
- REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 8 [06/2015 - 11/2018] , or refer to PROCEDURE - Step 8 [11/2018 - ]
- REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for Driver Side)
- Disconnect the 2 connectors.
- Remove the 7 screws.
- As shown in the illustration, slightly raise up the door trim upper panel assembly LH.
HINT:
Raise up the door trim upper panel assembly LH far enough that the front door pull handle can be removed.
*1 Door Trim Upper Panel Assembly LH Place Hands Here Raise Up - Remove the front door pull handle as shown in the illustration.
Remove in this Direction - Remove the 8 screws.
- Disengage the guide to remove the front door armrest base panel assembly LH.
Remove in this Direction - Remove the 3 screws and multiplex network master switch assembly.
- Disconnect the 2 connectors.
- REMOVE DOOR CONTROL SWITCH ASSEMBLY (for Front Passenger Side)
- Disconnect the 2 connectors.
- Remove the 7 screws.
- As shown in the illustration, slightly raise up the door trim upper panel assembly RH.
HINT:
Raise up the door trim upper panel assembly RH far enough that the front door pull handle can be removed.
*1 Door Trim Upper Panel Assembly RH Place Hands Here Raise Up - Remove the front door pull handle as shown in the illustration.
Remove in this Direction - Remove the 8 screws.
- Disengage the guide to remove the front door armrest base panel assembly RH as shown in the illustration.
Remove in this Direction - Disengage the claws to remove the door control switch assembly.
- Disconnect the 2 connectors.