Removal [06/2015 - 11/2018]: Procedure

PRECAUTION
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Refer to PRECAUTION [06/2015 - ]
CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS
Refer to PROCEDURE - Step 2
REMOVE LUGGAGE TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 2
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 3

REMOVE LOWER STEERING COLUMN COVER

Turn the steering wheel assembly to the left and remove the screw.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Turn the steering wheel assembly to the right and remove the screw.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the screw.

Push the left side of the lower steering column cover to disengage the claw and guides.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Push the right side of the lower steering column cover to disengage the claw and guides to remove the lower steering column cover.

REMOVE UPPER STEERING COLUMN COVER

Disengage the clips and guides to separate the meter hood spacer.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the claw and guides to remove the upper steering column cover.

REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

Disconnect the 2 connectors.

*a	Protective tape
	Remove in this Direction

Using a screwdriver with its tip wrapped in protective tape, disengage the claw to remove the windshield wiper switch assembly as shown in the illustration.
NOTE:
If the claw is pulled with excessive force, it may break.