LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transmission System (UA81E / UA81F) - Service Information (1 Of 2)) >> Transmission Control Cable >> Removal [10/2022 - 11/2023] >> Procedure

Removal [10/2022 - 11/2023]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 7

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 8

  3. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 9

  4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 10

  5. REMOVE FRONT FLOOR COVER LH 

    Refer to PROCEDURE - Step 3

  6. REMOVE COOL AIR INTAKE DUCT SEAL 
  7. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 3

  8. REMOVE AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 4

  9. REMOVE BATTERY 

    Refer to REMOVAL [10/2022 - 11/2023]

  10. DISCONNECT WIRE HARNESS 

    See step  6

  11. REMOVE BATTERY CLAMP SUB-ASSEMBLY 

    See step  7

  12. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [10/2022 - ]

  13. REMOVE NO. 1 SWITCH HOLE BASE 

    Refer to PROCEDURE - Step 20

  14. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 17

  15. REMOVE FRONT CONSOLE BOX INSERT 

    Refer to PROCEDURE - Step 41

  16. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY 
    NOTE:

    Before removing the transmission control cable assembly, check that the shift lever is in N.

    1. Disconnect the transmission control cable assembly from the transmission floor shift assembly.
      GTY943719Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.
      GTY858617Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Counterclockwise
    3. While disengaging the clip (A) as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip (A).
      GTY1113175Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Clip (A)
      *b 45° to 60°
      *c Clip (B)
    4. Remove the clip (B) and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
    5. Remove the nut and disconnect the transmission control cable assembly from the vehicle body.
      GTY1115723Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.
      GTY1115722Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals