DTC P0613-47: TCM Processor Watchdog/Safety MCU Failure [06/2018 - 09/2024]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Powertrain > Transmission > Clear DTCs 

5. Turn the engine switch off.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
2. Connect the cable to the negative (-) battery terminal.
3. Connect the Techstream to the DLC3.
4. Turn the engine switch on (IG).
5. Turn the Techstream on.
6. Wait for 1 second or more.
7. Enter the following menus: Powertrain / Transmission / Trouble Codes.
8. Read the DTCs.

   Powertrain > Transmission > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P0613-47 is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS 

Refer to CHECK FOR INTERMITTENT PROBLEMS [06/2018 - 09/2024]

Result: 

B 

See step  3

1. Replace the TCM.

   Refer to COMPONENTS [06/2018 - 01/2019] , or refer to COMPONENTS [01/2019 - 03/2019] , or refer to COMPONENTS [03/2019 - 09/2024]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM REGISTRATION AND INITIALIZATION 

for Registration: Refer to REGISTRATION [06/2018 - 09/2024]

for Initialization: Refer to INITIALIZATION [06/2018 - 09/2022] , or refer to INITIALIZATION [09/2022 - 11/2022] , or refer to INITIALIZATION [11/2022 - 09/2024]