DTC P0335-31: Crankshaft Position Sensor "A" No Signal [06/2018 - 01/2019]: Procedure

1. Check for smart key system DTCs.

   Refer to DTC CHECK / CLEAR [06/2018 - 01/2019]

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC B2286 and/or P0335 are output	B

Result: 

B 

GO TO SMART KEY SYSTEM. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2018 - 01/2019] 

Result: 

A 

See step  2

1. Disconnect the A47 ECM connector.
2. Disconnect the C80 TCM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A47-16 (NEO) - C80-43 (NE)	Always	Below 1 Ω
   A47-16 (NEO) or C80-43 (NE) - Body ground and other terminals	Always	10 kΩ or higher

4. Connect the C80 TCM connector.
5. Connect the A47 ECM connector.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Replace the TCM.

   Refer to COMPONENTS [06/2018 - 01/2019]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM REGISTRATION AND INITIALIZATION 

for Registration: Refer to REGISTRATION [06/2018 - 09/2024]

for Initialization: Refer to INITIALIZATION [06/2018 - 09/2022]