LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different car >> Section 392 (Acoustic Vehicle Alerting System - Service Information) >> Vehicle Approaching Speaker Ecu >> Removal [09/2022 - 09/2024] >> Procedure

Removal [09/2022 - 09/2024]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Toyota GR Corolla, 2025 Toyota Corolla, 2024 Toyota GR Corolla, 2024 Toyota Corolla, and 2023 Toyota GR Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 1 [11/2022 - ]

  2. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 3 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 3 [11/2022 - ]

  3. REMOVE FRONT DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 12 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 12 [11/2022 - ]

  4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 13 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 13 [11/2022 - ]

  5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH 

    Refer to PROCEDURE - Step 25 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 25 [11/2022 - 09/2024]

  6. REMOVE NO. 2 INSTRUMENT SIDE PANEL 

    Refer to PROCEDURE - Step 26 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 26 [11/2022 - 09/2024]

  7. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 17 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 17 [11/2022 - 09/2024]

  8. REMOVE AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 2

  9. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 19 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 19 [11/2022 - 09/2024]

  10. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 28 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 28 [11/2022 - 09/2024]

  11. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY 

    Refer to PROCEDURE - Step 29 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 29 [11/2022 - 09/2024]

  12. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 30 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 30 [11/2022 - 09/2024]

  13. REMOVE ECU INTEGRATION BOX RH 

    Refer to PROCEDURE - Step 14 [09/2022 - 11/2022] , or refer to PROCEDURE - Step 14 [11/2022 - 09/2024]

  14. REMOVE VEHICLE APPROACHING SPEAKER CONTROLLER 
    1. Disengage the 2 claws to remove the vehicle approaching speaker controller as shown in the illustration.
      GTY923196Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      NOTE:
      • If the ECU integration box RH is deformed or damaged, replace it.
      • Do not bend the 2 claws more than necessary.
scientia non olet · About LEMON Manuals