DTC C1ABC: Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete [04/2018 -]: Description
WARNING: This page is about a different variant/trim than selected.
This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1ABC | Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete | A beam axis inspection has not been performed | Blind spot monitor sensor LH |