DTC C1ABB: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete [04/2018 -]: Procedure
WARNING: This page is about a different variant/trim than selected.
- PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)
- Change the blind spot monitor sensor RH to Test Mode using the Techstream.
HINT:
Refer to Blind Spot Monitor Beam Axis Inspection.
Refer to ADJUSTMENT [04/2018 -]
Result
Proceed to NEXT
Result:
NEXT
END
- Change the blind spot monitor sensor RH to Test Mode using the Techstream.