DTC C1AB6: Blind Spot Monitor Master Module [04/2018 -]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC
- Turn the power switch off.
- Turn the power switch on (IG).
- Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 -]
Result:
NG
REPLACE BLIND SPOT MONITOR SENSOR RH. Refer to REMOVAL [04/2018 -]