DTC C1A47: Steering Angle Sensor [04/2018 -]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC
- Turn the power switch off.
- Turn the power switch on (IG).
- Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 -]
Result:
NG
See step 2
- REPLACE STEERING SENSOR
- Replace the steering sensor with a new or known good one.
Refer to REMOVAL [04/2018 - 08/2021] , or refer to REMOVAL [08/2021 -]
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Replace the steering sensor with a new or known good one.
- RECHECK DTC
- Turn the power switch off.
- Turn the power switch on (IG).
- Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
Result
Result Proceed to No DTCs are output A DTC C1A47 is output ("Blind Spot Monitor Master") B DTC C1A47 is output ("Blind Spot Monitor Slave") C
Result:
A
END
Result:
B
REPLACE BLIND SPOT MONITOR SENSOR RH. Refer to REMOVAL [04/2018 -]
Result:
C
REPLACE BLIND SPOT MONITOR SENSOR LH. Refer to REMOVAL [04/2018 -]