LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 44 (Hybrid Transmission (Service Information) [P710]) >> Shift Paddle Switch >> Installation [04/2018 - ] >> Procedure

Installation [04/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL NO. 1 SWITCH WIRE 

    HINT: 

    Perform this procedure only when replacement of the No. 1 switch wire is necessary.

    1. Engage the 2 guides to install the No. 1 switch wire to the steering wheel assembly.
  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) 
    1. Connect the No. 1 transmission shift switch assembly connector and No. 2 transmission shift switch assembly connector to install the No. 1 transmission shift switch assembly and No. 2 transmission shift switch assembly to the No. 1 switch wire.
    2. Engage the 2 clamps.
    3. Engage the 4 claws to install the shift paddle switch (transmission shift switch assembly) to the steering wheel assembly.
    4. Install 2 new screws.

      Torque: 1.7 N*m (17 kgf*cm, 15 in.*lbf) 

  3. INSTALL STEERING PAD SWITCH ASSEMBLY 

    Refer to PROCEDURE - Step 1

  4. INSTALL STEERING WHEEL ASSEMBLY 

    Refer to INSTALLATION [04/2018 - 08/2020] , or refer to INSTALLATION [08/2020 - ]

scientia non olet · About LEMON Manuals