Installation [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL PUMP CONTROL ECU BRACKET
1. Install the fuel pump control ECU bracket to the fuel pump control ECU with the 2 bolts.
  Torque: 4.5 N*m (6 kgf*cm, 40 in.*lbf)
INSTALL FUEL PUMP CONTROL ECU
1. Install the fuel pump control ECU to the vehicle body with the nut.
  Torque: 8.0 N*m (2 kgf*cm, 71 in.*lbf)
2. Connect the 2 fuel pump control ECU connectors.
INSTALL ROOM PARTITION BOARD LH
Refer to PROCEDURE - Step 4
INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
Refer to PROCEDURE - Step 6
INSTALL REAR SEAT SHOULDER BELT COVER
Refer to PROCEDURE - Step 7
INSTALL ROOF SIDE INNER GARNISH LH
Refer to PROCEDURE - Step 18
INSTALL ROOF SIDE INNER GARNISH RH
HINT:

Use the same procedure as for the LH side.
INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY LH
Refer to PROCEDURE - Step 19
INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY RH
HINT:

Use the same procedure as for the LH side.
CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 1
CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Refer to PROCEDURE - Step 1
CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH
Refer to PROCEDURE - Step 9
CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH
HINT:

Use the same procedure as for the LH side.
INSTALL LUGGAGE COMPARTMENT INNER TRIM PAD (w/o Seat Heater System)
Refer to PROCEDURE - Step 15
INSTALL CENTER STOP LIGHT SET
Refer to INSTALLATION [04/2018 - ]
INSTALL REAR SEAT ASSEMBLY
Refer to INSTALLATION [08/2020 - ]