LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Battery / Charging System (Service Information)) >> Generator >> Installation [12/2015 - 08/2016] >> Procedure

Installation [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL GENERATOR ASSEMBLY 
    1. Install the wire harness clamp stay with the bolt.

      Torque: 8.4 N*m (85 kgf*cm, 74 in.*lbf) 

    2. Connect the wire harness clamp.
    3. Install the generator assembly to the cylinder block sub-assembly with the generator bracket, bolt and nut.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    4. Install the 2 bolts.

      Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

    5. Connect the generator connector to the generator assembly.
    6. Install the generator wire with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    7. Install the terminal cap.
    8. Connect the 3 wire harness clamps.
    9. Connect the magnetic clutch connector to the compressor and magnetic clutch.
  2. INSTALL FAN & GENERATOR V BELT 

    (Refer to PROCEDURE - Step 1 )

  3. INSTALL RADIATOR ASSEMBLY WITH FAN SHROUD AND FAN MOTOR 

    (Refer to INSTALLATION [12/2015 - 08/2016] )

  4. INSTALL FRONT BUMPER ASSEMBLY 

    (Refer to INSTALLATION [12/2015 - 11/2017] )

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [12/2015 - 08/2016] ).

scientia non olet · About LEMON Manuals