Installation [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FAN AND GENERATOR V BELT

Install the fan and generator V belt.

Fig 1: Fan And Generator V Belt Routing

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

*1	Water Pump
*2	Idler
*3	Generator
*4	Crankshaft
*5	Tensioner
*6	A/C Compressor

Turn the V-ribbed belt tensioner counterclockwise and remove the 5 mm hexagon wrench.
After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

INSTALL FRONT FENDER APRON SEAL RH
See step 97
INSTALL FRONT WHEEL RH
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)