Installation [12/2015 - 08/2016]: Procedure

1. Pass the transmission control cable from the cabin into the engine compartment.
2. Install the transmission control cable with the 3 bolts.

   Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

3. Install a new clip onto the control cable bracket.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *1	Claw A
   *2	Claw B
   *3	Transmission Control Cable

4. Install the transmission control cable onto the transmission control cable bracket.
   NOTE:

   • Make sure that the claws A (*1) on the clip are securely fit into the bracket holes.
   • Make sure that the cable is securely installed inside of the claws B (*2) of the clip.
   • After installation, lightly jiggle the transmission control cable and make sure that it does not come loose from the transmission control cable bracket.
5. Check that the park/neutral position switch is in the N position.
6. Connect the transmission control cable onto the transmission control shaft lever with the nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf) 

7. Rotate the transmission control cable nut counterclockwise approximately 270° and, while holding the nut in that position, press in the stopper until it makes 2 "click" sounds.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *1	Stopper
   *2	Nut
   *a	Turn
   *b	Push

8. Push the lock piece up from the back side of the adjuster case while pinching the claws on the lock piece.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *1	Adjuster Case
   *2	Claw
   *3	Lock Piece

9. Connect the cable outer of the transmission control cable onto the shift lever retainer, check that the position of the spring is the same as A shown in the illustration, and press in the stopper.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   If the stopper cannot be pressed in, slightly rotate the nut clockwise and then press in the stopper.

10. Connect the transmission control cable end to the shift lever.

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    TEXT IN ILLUSTRATION
    
    

    *1	Lock Piece

    NOTE:

    Check that the lock piece is pulled up.

1. Install the front No. 1 floor heat insulator to the body with the 2 nuts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

(Refer to INSTALLATION [12/2015 - 08/2016] )

Refer to PROCEDURE - Step 4

Refer to PROCEDURE - Step 61

Refer to PROCEDURE - Step 62

(Refer to INSTALLATION [12/2015 - 08/2016] )

Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

1. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [12/2015 - 08/2016] ).

See step  1