LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Lubrication System [2GR-FE] (Service Information)) >> Oil Pressure Switch >> Removal [12/2015 - 08/2016] >> Procedure

Removal [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT WHEEL RH (w/ Oil Cooler) 
  2. REMOVE NO. 1 ENGINE UNDER COVER (w/o Oil Cooler) 

    Refer to PROCEDURE - Step 4

  3. REMOVE FRONT FENDER APRON SEAL RH (w/ Oil Cooler) 

    Refer to PROCEDURE - Step 10

  4. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY (w/o Oil Cooler) 
    1. Disconnect the engine oil pressure switch assembly connector.
    2. Using a deep socket wrench, remove the engine oil pressure switch assembly.
      GTY301114Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY (w/ Oil Cooler) 
    1. Disconnect the engine oil pressure switch assembly connector.
    2. Using a deep socket wrench, remove the engine oil pressure switch assembly.
      GTY308242Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals