Charge Warning Light Comes ON while Driving [12/2015 - 08/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK LOCK FUNCTION OF GENERATOR CLUTCH PULLEY
- Check the lock function with the pulley installed in the vehicle.
- Visually check that the rotor in the generator assembly operates with the engine running.
- Check the lock function with the pulley removed from the vehicle.
- Remove the generator pulley cap.
- Hold the generator rotor assembly using SST, and turn the generator clutch pulley clockwise to check that the outer ring locks (Refer to PROCEDURE - Step 5
).TEXT IN ILLUSTRATION
*a Free *b Lock OK
The outer ring locks.
- SST: 09820-63021
Result:
NG
REPLACE GENERATOR CLUTCH PULLEY
(Refer to COMPONENTS [12/2015 - 08/2016] )
Result:
OK
See step 2
- Check the lock function with the pulley installed in the vehicle.
- CHECK LOCK OF GENERATOR CLUTCH PULLEY
- Start the engine and visually check the generator clutch pulley for looseness.
OK
The clutch pulley is not loose.
Result:
OK
REPLACE GENERATOR ASSEMBLY
(Refer to COMPONENTS [12/2015 - 08/2016] )
Result:
NG
TIGHTEN GENERATOR CLUTCH PULLEY TO THE SPECIFIED TORQUE
- Start the engine and visually check the generator clutch pulley for looseness.