LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Starting System [2GR-FE] (Service Information)) >> Starter >> Installation [12/2015 - 08/2016] >> Procedure

Installation [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    2. Connect the starter connector.
    3. Connect the terminal 30 with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    4. Close the terminal cap.
  2. INSTALL AIR CLEANER AND HOSE 

    Refer to PROCEDURE - Step 4

  3. INSTALL BATTERY 

    Refer to PROCEDURE - Step 61

  4. INSTALL AIR CLEANER INLET COVER ASSEMBLY SEAL 

    Refer to PROCEDURE - Step 62

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [12/2015 - 08/2016] )

scientia non olet · About LEMON Manuals