LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Emission Control System [2GR-FE] (Service Information)) >> Purge Valve >> Installation [12/2015 - 08/2016] >> Procedure

Installation [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL PURGE VSV 
    1. Install the purge VSV with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    2. Connect the fuel vapor feed hose assembly and No. 1 fuel vapor feed hose.
    3. Connect the wire harness clamp.
    4. Connect the purge VSV connector.
  2. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 95

scientia non olet · About LEMON Manuals