Installation [08/2015 - 08/2018]: Procedure
WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL POWER STEERING OIL PRESSURE SWITCH
- Install a new O-ring to the oil pressure switch.
- Apply a light coat of engine oil to the O-ring of the oil pressure switch.NOTE:
- When reusing the oil pressure switch, inspect the O-ring.
- If the O-ring has scratches or cuts, replace the new O-ring.
- Using a 24 mm deep socket wrench, install the oil pressure switch.
Torque: 21 N.m (214 kgf/cm, 15 ft.lbf)
- Connect the oil pressure switch connector.
- ADD POWER STEERING FLUID
- BLEED POWER STEERING FLUID
Refer to PROCEDURE - Step 2
- INSPECT FOR POWER STEERING FLUID LEAK
- INSTALL FRONT FENDER APRON SEAL RH
Refer to PROCEDURE - Step 17