LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Control System (3UR-FBE) (Service Information)) >> Engine Coolant Temperature Sensor >> Removal [08/2015 - 08/2018] >> Procedure

Removal [08/2015 - 08/2018]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 2

  2. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 2

  3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    GTY588685Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the sensor connector.
    2. Using a 19 mm ball joint lock nut wrench, remove the sensor.
    3. Remove the gasket from the sensor.
scientia non olet · About LEMON Manuals