Installation [08/2019 - ]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Sequoia, 2021 Toyota Sequoia, and 2020 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL DCM (TELEMATICS TRANSCEIVER)
INSTALL NO. 2 TELEPHONE BRACKET
1. Install the No. 2 telephone bracket with the 2 screws.
  Torque: 4.5 N.m (46 kgf/cm, 40 in.lbf)
INSTALL NO. 1 TELEPHONE BRACKET
1. Install the No. 1 telephone bracket with the 2 screws.
  Torque: 4.5 N.m (46 kgf/cm, 40 in.lbf)
INSTALL DCM (TELEMATICS TRANSCEIVER) WITH BRACKET
1. Install the DCM (telematics transceiver) with the 2 nuts.
  Torque: 7.0 N.m (71 kgf/cm, 62 in.lbf)
INSTALL DCM (TELEMATICS TRANSCEIVER) WITH CERTIFICATION ECU
1. Install the DCM (telematics transceiver) with certification ECU with the 2 nuts.
2. Connect the 9 connectors.
INSTALL NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 23
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
Refer to PROCEDURE - Step 24
INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL LOWER INSTRUMENT PANEL
Refer to PROCEDURE - Step 26
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 27
INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 29
INSTALL COWL SIDE TRIM BOARD RH
Refer to PROCEDURE - Step 46
INSTALL FRONT DOOR SCUFF PLATE RH
Refer to PROCEDURE - Step 48
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2019 - ]
CHECK SRS WARNING LIGHT
Refer to OPERATION CHECK [08/2019 - ]
PERFORM DCM ACTIVATION
Refer to DCM ACTIVATION [08/2019 - ]
PERFORM REGISTRATION
NOTE:
When replacing the DCM (telematics transceiver), perform registration.

Refer to REGISTRATION [08/2019 - ]