Installation [08/2015 - ]: Procedure

1. Clean the ECM seal's surface with non-residue solvent.
2. Attach a new gasket to the ECM.

1. Install the ECM with the 4 bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

   NOTE:

   • Make sure that the gasket is not folded or caught on any area on the surrounding part.
   • Make sure that there is no foreign matter caught between the gasket and surrounding part.
   • Do not damage the gasket.
2. Connect the 2 ECM connectors and push each lock lever down to lock the ECM connectors.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Make sure that the lock lever is raised 90° before connecting the ECM connectors. Failure to do this may cause the lock lever and terminals to break.
   • Do not twist the wire harness when connecting the ECM connectors.

1. Connect the connector holder block with the 3 bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 7.3 N.m (74 kgf/cm, 65 in.lbf) 

Refer to PROCEDURE - Step 14

1. Perform initialization procedures. Refer to:

   INITIALIZATION [08/2015 - 08/2017]

   INITIALIZATION [08/2017 - 08/2018]

   INITIALIZATION [08/2018 - 08/2019]

   INITIALIZATION [08/2019 - ]