LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Door Lock System (Service Information) >> Front Door Lock >> Removal [08/2019 - ] >> Procedure

Removal [08/2019 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [08/2019 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2019 - ] ).

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH 

    Refer to PROCEDURE - Step 4

  4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers) 

    Refer to PROCEDURE - Step 3

  5. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG 

    Refer to PROCEDURE - Step 5

  6. REMOVE FRONT ARMREST BASE UPPER PANEL 

    Refer to PROCEDURE - Step 6

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7

  8. REMOVE FRONT DOOR TRIM NO. 1 BRACKET 

    Refer to PROCEDURE - Step 17

  9. REMOVE FRONT DOOR SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 18

  10. REMOVE FRONT DOOR GLASS RUN 

    Refer to PROCEDURE - Step 19

  11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 20

  12. REMOVE FRONT DOOR FRAME REAR LOWER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 23

  13. REMOVE FRONT DOOR LOCK 
    1. Using a "TORX" socket wrench T30, remove the 3 screws.
      GTY610817Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Slide the front door lock downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock and cables as a unit.
    3. Remove the door lock wire harness seal from the front door lock.
    4. Remove the front door lock remote control cable.
      GTY590071Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.
      GTY573358Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove the front door inside locking cable.
      GTY590073Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals