LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Pattern Select Switch >> Removal [12/2013 - ] >> Procedure

Removal [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. REMOVE FRONT PANEL GARNISH LH 

    Refer to PROCEDURE - Step 2

  3. REMOVE FRONT PANEL GARNISH RH 

    Refer to PROCEDURE - Step 3

  4. REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH 

    Refer to PROCEDURE - Step 4

  5. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH 

    Refer to PROCEDURE - Step 5

  6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 6

  7. REMOVE NO. 2 SWITCH HOLE BASE 

    Refer to PROCEDURE - Step 31

  8. REMOVE PATTERN SELECT SWITCH ASSEMBLY 
    GTY429761Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disengage the 2 claws and remove the pattern select switch assembly from the No. 1 switch hole base.
scientia non olet · About LEMON Manuals