LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Intake / Exhaust System (1AR-FE) (Service Information) (Except Hybrid)) >> Vacuum Switching Valve (For ACIS) >> Installation [12/2013 - ] >> Procedure

Installation [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) 
    1. Install the vacuum hose clamp with the bolt.

      Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf) 

    2. Install the vacuum switching valve assembly (for ACIS) to the intake manifold with the bolt.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

    3. Connect the vacuum switching valve assembly (for ACIS) connector.
    4. Connect the 2 vacuum hoses.
    5. Engage the wire harness clamp.
    6. Connect the union to vacuum tube hose to the vacuum hose clamp.
  2. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 10 , or refer to PROCEDURE - Step 10 , or refer to PROCEDURE - Step 10

  3. INSTALL NO. 2 HOSE CLAMP BRACKET 

    Refer to PROCEDURE - Step 3

  4. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY 

    Refer to INSTALLATION [12/2013 - ]

scientia non olet · About LEMON Manuals