Installation [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TCM

Temporarily install the TCM to the automatic transaxle assembly with the 2 bolts.
Tighten the 2 bolts in the order shown in the illustration.
Torque: 11.3 N*m (115 kgf*cm, 8 ft.*lbf)

Fig 1: Tightening Sequence Of TCM Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect the TCM connector.

Turn the lock lever to secure the connector.

INSTALL AIR CLEANER CASE SUB-ASSEMBLY
Refer to PROCEDURE - Step 54
INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
Refer to PROCEDURE - Step 55
INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 3
INSTALL INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 57
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 4
INSTALL RADIATOR SIDE SEAL RH
Refer to PROCEDURE - Step 5
INSTALL RADIATOR SIDE DEFLECTOR SEAL LH
Refer to PROCEDURE - Step 6
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [12/2013 - 11/2016]
CHECK AUTOMATIC TRANSAXLE SYSTEM
NOTE:
If automatic transaxle parts have been replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary.

Refer to PRECAUTION [12/2013 - 11/2016]