LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Starting System (2GR-FE) (Service Information) (Except Hybrid)) >> Starter >> Installation [12/2013 - 11/2016] >> Procedure

Installation [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    2. Connect the starter assembly connector.
    3. Connect terminal 30 with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    4. Close the terminal cap.
  2. INSTALL BATTERY 

    Refer to PROCEDURE - Step 53

  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 54

  4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 55

  5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 3

  6. INSTALL INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 57

  7. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 84

  8. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 4

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2013 - 11/2016]

scientia non olet · About LEMON Manuals