LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Prius One >> Repair and Diagnosis >> External Pages >> Different car >> Section 349 (Starting System (Service Information) [2GR-FKS]) >> Starter >> Installation [04/2018 -] >> Procedure

Installation [04/2018 -]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 46 N*m (469 kgf*cm, 34 ft.*lbf) 

    2. Connect the engine wire to the terminal 30 with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    3. Close the terminal cap.
    4. Connect the starter assembly connector.
  2. INSTALL BATTERY CLAMP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 40

  3. INSTALL ECM 

    Refer to PROCEDURE - Step 3

  4. INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 44

  5. INSTALL INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 45

  6. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 46

  7. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 2 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 2 [08/2021 -]

  8. INSTALL BATTERY 

    Refer to INSTALLATION [04/2018 -]

scientia non olet · About LEMON Manuals