Installation [04/2018 - 08/2021]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT BUMPER ASSEMBLY

Move the front bumper assembly into position and engage the 2 guides as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install in this Direction

Install the 4 bolts.
w/ Intuitive Parking Assist System:
1. Connect the connector.
Connect the connector.

Engage the 4 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install in this Direction

Install the 8 screws.
Install the screw.
HINT:

Use the same procedure for the RH side and LH side.
Install the front bumper assembly with the 2 clips.
HINT:

Use the same procedure for the RH side and LH side.

INSTALL COOL AIR INTAKE DUCT SEAL

Engage the guide as shown in the illustration.

	Install in this Direction (1)
	Install in this Direction (2)

Install the cool air intake duct seal with the 7 clips.

ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
for HV Model:

Refer to CALIBRATION [04/2018 - ]

for Gasoline Model:

Refer to CALIBRATION [04/2018 - ]
PERFORM CALIBRATION (w/ Intelligent Clearance Sonar System)
for HV Model:

Refer to CALIBRATION [04/2018 - ]

for Gasoline Model:

Refer to CALIBRATION [04/2018 - ]
ADJUST HEADLIGHT AIMING
HINT:

Perform this procedure only when the front bumper reinforcement has been replaced.

Refer to ADJUSTMENT [04/2018 - ]