Installation [11/2016 - ]: Procedure

1. Install the radiator pipe clamp to the camshaft housing sub-assembly LH with the bolt.

   Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

1. Install the wire harness clamp bracket to the camshaft housing sub-assembly with the bolt.

   Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf) 

2. Install the wire harness clamp bracket to the cylinder head cover LH with the bolt.

   Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf) 

3. Install the wire harness clamp bracket to the camshaft housing sub-assembly with the bolt.

   Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf) 

1. Install the rear engine mounting bracket to the cylinder block sub-assembly with the 3 bolts.

   Torque: 64 N*m (653 kgf*cm, 47 ft.*lbf) 

1. Install the rear engine mounting bracket to the cylinder block sub-assembly with the 3 bolts.

   Torque: 64 N*m (653 kgf*cm, 47 ft.*lbf) 

1. Install the No. 5 cylinder block insulator to the engine assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Fastener Surface

   NOTE:

   Make sure that the No. 5 cylinder block insulator is not covering any fastener surface.

1. Install a new engine oil level dipstick guide O-ring to the engine oil level dipstick guide.
2. Apply a light coat of engine oil to the engine oil level dipstick guide O-ring.
3. Insert the engine oil level dipstick guide end into the oil pan sub-assembly.
4. Install the engine oil level dipstick guide to the camshaft housing sub-assembly LH with the bolt.

   Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

5. Install the engine oil level dipstick to the engine oil level dipstick guide.

Refer to PROCEDURE - Step 2

1. Install the V-ribbed belt tensioner assembly with the 2 bolts.

   Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

Refer to PROCEDURE - Step 3

1. Install the No. 1 compressor mounting bracket to the cylinder block sub-assembly with the 2 bolts.

   Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

   NOTE:

   Temporarily tighten the bolt (A), and then fully tighten the 2 bolts in the order of (B) and (A).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 1

See step  1

1. Install the No. 2 ventilation hose to the cylinder head cover sub-assembly and slide the clip to secure it.

1. Install the ventilation hose to the PCV valve (ventilation valve sub-assembly) and slide the clip to secure it.

1. Install the No. 2 water by-pass hose to the water outlet and slide the clip to secure it.

1. Install the No. 3 water by-pass hose to the water inlet pipe and slide the clip to secure it.

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 2

1. Engage the 2 clamps and install the sensor wire to the water inlet pipe with the bolt.

   Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

Refer to INSTALLATION [11/2016 - ]