Installation [11/2016 - ]: Procedure

1. Install the wire harness clamp bracket with the bolt.

   Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf) 

2. Type A:
   1. Install the generator assembly with the 2 bolts.

      Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

   2. Temporarily install the generator assembly bracket with the 2 bolts.
   3. Fully tighten the 2 bolts.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

3. Type B:
   1. Install the generator assembly bracket to the generator assembly with the bolt.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   2. Install the generator assembly with the 2 bolts.

      Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

   3. Install the nut.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

4. Engage the 2 wire harness clamps.
5. Connect the magnetic clutch connector.
6. Connect the generator assembly connector.
7. Connect the wire harness to terminal B with the nut.

   Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

8. Close the terminal cap.

Refer to INSTALLATION [11/2016 - ]

Refer to INSTALLATION [11/2016 - ]