LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (SFI System [2GR-FE] - Diagnostic Codes - (Except Hybrid) (3 Of 5)) >> SFI System >> DTC P0116: Engine Coolant Temperature Circuit Range / Performance [12/2013 - 11/2016] >> Description

DTC P0116: Engine Coolant Temperature Circuit Range / Performance [12/2013 - 11/2016]: Description

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DTC P0115.

Refer to DESCRIPTION 

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P0116 Engine Coolant Temperature Circuit Range / Performance Either of the following conditions is met (2 trip detection logic):
  • When engine is started cold and warmed up, the engine coolant temperature sensor value does not change.
  • After the warmed up engine is stopped and then next cold engine start is performed, the engine coolant temperature sensor value does not change.

For Mexico Models:
Case 1:
The engine coolant temperature is between 35 and 60°C (95 and 140°F) when the engine is started, and both of the following conditions are met (2 trip detection logic)
  • (a) Vehicle driven at varying speeds (accelerated and decelerated)
  • (b) Engine coolant temperature remains within 3°C (5.4°F) of initial engine coolant temperature

Case 2:
The engine coolant temperature is higher than 60°C (140°F) when the engine is started, and both of the following conditions are met (6 trip detection logic)
  • (a) Vehicle driven at varying speeds (accelerated and decelerated)
  • (b) Engine coolant temperature measurements remain within 1°C (1.8°F) of initial engine coolant temperature
  • Thermostat
  • Engine coolant temperature sensor
Comes on DTC stored DTC for Mexico Models
- Applies