LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Intake / Exhaust System (2GR-FKS) - Service Information (Except Hybrid)) >> VACUUM SWITCHING VALVE (for ACIS) >> Installation [06/2017 - ] >> Procedure

Installation [06/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL NO. 1 VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) 
    1. Install the No. 1 vacuum switching valve assembly (for ACIS) to the intake air surge tank assembly with the bolt.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

    2. Connect the 2 vacuum hose sub-assemblies to the No. 1 vacuum switching valve assembly (for ACIS).
    3. Connect the No. 1 vacuum switching valve assembly (for ACIS) connector.
  2. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 46 [06/2017 - 10/2020] , or refer to PROCEDURE - Step 46 [10/2020 - ]

scientia non olet · About LEMON Manuals