Installation [06/2017 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
- Install the vacuum switching valve (for active control engine mount system) to the front engine mounting insulator with the nut.
Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
- Connect the 3 vacuum hoses to the vacuum switching valve (for active control engine mount system).
- Engage the wire harness clamp and connect the vacuum switching valve (for active control engine mount system) connector.
- Install the 2 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Engage the wire harness clamp and install the engine wire with the bolt.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
- Install the vacuum switching valve (for active control engine mount system) to the front engine mounting insulator with the nut.
- INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 44 [06/2017 - 10/2020] , or refer to PROCEDURE - Step 44 [10/2020 - ]
- INSTALL INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 45 [06/2017 - 10/2020] , or refer to PROCEDURE - Step 45 [10/2020 - ]
- INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 2 [06/2017 - 10/2020] , or refer to PROCEDURE - Step 2 [10/2020 - ]