DTC P08BA-14: Pressure Control Solenoid "L" Circuit Short to Ground or Open [06/2017 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK HARNESS AND TRANSMISSION WIRE (TRANSMISSION WIRE (SOLENOID (SL6) VALVE) - ECM)
- Disconnect the C96 ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C96-32 (SL6+) - C96-33 (SL6-) 20°C (68°F) 5.0 to 5.6 Ω C96-32 (SL6+) or C96-33 (SL6-) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
See step 3
Result:
OK
See step 2
- REPLACE ECM
- Replace the ECM.
Refer to REMOVAL [06/2017 - 10/2020] , or refer to REMOVAL [10/2020 - 08/2022] , or refer to REMOVAL [08/2022 - ]
Result
Proceed to NEXT
Result:
NEXT
PERFORM REGISTRATION. Refer to REGISTRATION [06/2017 - ]
- Replace the ECM.
- CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)
- Disconnect the C92 transmission wire connector.
- Disconnect the C96 ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C92-9 (SL6+) - C96-32 (SL6+) Always Below 1 Ω C92-8 (SL6-) - C96-33 (SL6-) Always Below 1 Ω C92-9 (SL6+) or C96-32 (SL6+) - Body ground and other terminals Always 10 kΩ or higher C92-8 (SL6-) or C96-33 (SL6-) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TRANSMISSION WIRE - ECM)
Result:
OK
See step 4
- INSPECT SOLENOID (SL6) VALVE
- Remove the solenoid (SL6) valve.
*a Component without harness connected
(Solenoid (SL6) Valve)Refer to DISASSEMBLY [06/2017 - ]
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Solenoid (SL6) valve connector terminal 1 - terminal 2 20°C (68°F) 5.0 to 5.6 Ω - Connect a positive (+) lead from the battery with a 21 W bulb to terminal 1 and a negative (-) lead to terminal 2 of the solenoid valve connector. Check that the valve moves and makes an operating sound.
OK
Valve moves and makes an operating sound.
Result
Proceed to OK NG
Result:
OK
REPAIR OR REPLACE TRANSMISSION WIRE. Refer to COMPONENTS [06/2017 - 10/2020] , or refer to COMPONENTS [10/2020 - 08/2021] , or refer to COMPONENTS [08/2021 - ]
Result:
NG
REPLACE SOLENOID (SL6) VALVE. Refer to COMPONENTS [06/2017 - ]
- Remove the solenoid (SL6) valve.