LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System (2GR-FKS) - Diagnostics - Introduction (1 Of 4) (Except Hybrid)) >> SFI System >> Basic Inspection [06/2017 - ] >> Procedure

Basic Inspection [06/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK BATTERY VOLTAGE 
    NOTE:

    Carry out this check with the engine stopped and the engine switch off.

    Result

    Result Proceed to
    11 V or higher OK
    Below 11 V NG

    Result: 

    NG 

    CHARGE OR REPLACE BATTERY 

    Result: 

    OK 

    See step  2

  2. CHECK WHETHER ENGINE CRANKS 

    Result

    Proceed to
    OK
    NG

    Result: 

    NG 

    PROCEED TO PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2017 - 08/2018]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2018 - ]  

    Result: 

    OK 

    See step  3

  3. CHECK WHETHER ENGINE STARTS 

    Result

    Proceed to
    OK
    NG

    Result: 

    NG 

    See step  6

    Result: 

    OK 

    See step  4

  4. CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 
    1. Visually check that the air cleaner filter element sub-assembly is not excessively contaminated with dirt or oil.

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 

    Result: 

    OK 

    See step  5

  5. CHECK IDLE SPEED 
    1. Check the engine idle speed.

      Refer to PROCEDURE - Step 10 [06/2017 - 09/2019] , or refer to PROCEDURE - Step 10 [09/2019 - ]

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    PROCEED TO AND CONTINUE TO TROUBLESHOOT 

    Result: 

    OK 

    See step  6

  6. CHECK FUEL PRESSURE 
    1. Check the fuel pressure.

      Refer to PROCEDURE - Step 2

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    PROCEED TO AND CONTINUE TO TROUBLESHOOT 

    Result: 

    OK 

    See step  7

  7. CHECK FOR SPARK 
    1. Perform a spark test.

      Refer to PROCEDURE - Step 1

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    PROCEED TO PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2017 - 08/2018]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2018 - ]  

    Result: 

    NG 

    PROCEED TO AND CONTINUE TO TROUBLESHOOT 

scientia non olet · About LEMON Manuals