Installation [06/2017 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
- Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Adhesive
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
*a Adhesive 1344 *b Oil Inlet Port NOTE:- Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
- Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.
- Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.
Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
NOTE:Do not start the engine for at least 1 hour after installation.
- Connect the engine oil pressure switch assembly connector.
- Engage the clamp to connect the wire harness protector.
- Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
- ADD ENGINE OIL
Refer to PROCEDURE - Step 8 [06/2017 - 08/2021] , or refer to PROCEDURE - Step 8 [08/2021 - ]
- CHECK ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1 [06/2017 - 08/2023] , or refer to PROCEDURE - Step 1 [08/2023 - ]
- INSPECT FOR OIL LEAK
Refer to PROCEDURE - Step 9 [06/2017 - 08/2021] , or refer to PROCEDURE - Step 9 [08/2021 - ]
- INSTALL FRONT FENDER APRON SEAL RH
Refer to PROCEDURE - Step 66 [06/2017 - 10/2020] , or refer to PROCEDURE - Step 66 [10/2020 - ]