Installation [06/2017 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL PURGE VALVE (PURGE VSV)
- Install the purge valve (purge VSV) to the intake air surge tank assembly with the bolt.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
*1 No. 1 Fuel Vapor Feed Hose *2 Fuel Vapor Feed Hose *a View A *b RH Side *c Front *d 120° - Connect the No. 1 fuel vapor feed hose to the purge valve (purge VSV).
- Connect the fuel vapor feed hose to the purge valve (purge VSV) and slide the clip to secure it.
HINT:
Engage the clip within the area shown in the illustration.
- Connect the purge valve (purge VSV) connector.
- Install the purge valve (purge VSV) to the intake air surge tank assembly with the bolt.
- INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 46 [06/2017 - 10/2020] , or refer to PROCEDURE - Step 46 [10/2020 - ]