Installation [06/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
1. Apply a light coat of engine oil to the O-ring.
2. Using a 22 mm deep socket wrench, install the PCV valve (ventilation valve sub-assembly) to the cylinder head cover sub-assembly LH.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  NOTE:
  When reusing the PCV valve (ventilation valve sub-assembly), inspect the O-ring.
CONNECT VENTILATION HOSE
1. Connect the ventilation hose to the PCV valve (ventilation valve sub-assembly) and slide the clip to secure it.
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 46 [06/2017 - 10/2020] , or refer to PROCEDURE - Step 46 [10/2020 - ]