Removal [10/2020 - ]: Procedure
- PRECAUTION NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [03/2020 - ]
- REMOVE BATTERY
Refer to REMOVAL [10/2020 - ]
- REMOVE COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 1
- REMOVE V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 19 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 19 [08/2022 - 08/2023] , or refer to PROCEDURE - Step 19 [08/2023 - ]
- REMOVE INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 20 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 20 [08/2022 - 08/2023] , or refer to PROCEDURE - Step 20 [08/2023 - ]
- REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 21 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 21 [08/2022 - 08/2023] , or refer to PROCEDURE - Step 21 [08/2023 - ]
- REMOVE ECM
Refer to PROCEDURE - Step 5 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 5 [08/2022 - ]
- REMOVE BATTERY CLAMP SUB-ASSEMBLY
Refer to PROCEDURE - Step 25 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 25 [08/2022 - 08/2023] , or refer to PROCEDURE - Step 25 [08/2023 - ]
- REMOVE STARTER ASSEMBLY