Removal [06/2017 - ]: Procedure

Refer to PROCEDURE - Step 1

1. Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this step.
   • Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.
2. Using a screwdriver with its tip wrapped with protective tape, disconnect the No. 2 parking brake wire assembly connector from the rear axle hub and bearing assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protective Tape

   NOTE:

   Be careful not to damage the rear axle hub and bearing assembly or connector cover.

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 15

1. Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle carrier sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002