Removal [11/2016 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE FRONT FENDER APRON SEAL RH
Refer to PROCEDURE - Step 17
- DRAIN ENGINE OIL
See step 1
- REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
- Disconnect the wire harness protector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
| *1 |
Wire Harness Protector |
- Disconnect the engine oil pressure switch assembly connector.
- Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly from the oil pan sub-assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|