Removal [11/2016 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- DRAIN ENGINE OIL
See step 1
- REMOVE FRONT FRAME ASSEMBLY
Refer to PROCEDURE - Step 39
- SUPPORT AUTOMATIC TRANSAXLE ASSEMBLY
- Set an engine lifter.
WARNING:
To prevent the engine assembly with automatic transaxle assembly from falling while servicing, do not remove SST.
NOTE:
Make sure that there is clearance between the automatic transaxle assembly and engine lifter.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE BELT
Refer to PROCEDURE - Step 40
- REMOVE NO. 2 OIL PAN SUB-ASSEMBLY
Refer to PROCEDURE - Step 32
- REMOVE OIL STRAINER SUB-ASSEMBLY
Refer to PROCEDURE - Step 33
- REMOVE ENGINE OIL LEVEL SENSOR
- Remove the clip from the engine oil level sensor.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the 2 nuts and engine oil level sensor from the oil pan sub-assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|