Installation [11/2016 - ]: Procedure
- INSTALL SPARK PLUG
HINT:
Perform "Inspection After Repair" after replacing a spark plug.
Refer to INITIALIZATION [11/2016 - ]
- Install the 6 spark plugs to the cylinder head sub-assembly and cylinder head LH.
Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf)
NOTE:If a spark plug has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
- Install the 6 spark plugs to the cylinder head sub-assembly and cylinder head LH.
- INSTALL IGNITION COIL ASSEMBLY
HINT:
Perform "Inspection After Repair" after replacing an ignition coil assembly.
Refer to INITIALIZATION [11/2016 - ]
- Install the 6 ignition coil assemblies to the cylinder head cover sub-assembly and cylinder head cover sub-assembly LH with the 6 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
- Connect the 6 ignition coil assembly connectors.
- Install the 6 ignition coil assemblies to the cylinder head cover sub-assembly and cylinder head cover sub-assembly LH with the 6 bolts.
- INSTALL NO. 1 ENGINE COVER
See step 5
- INSTALL EGR COOLER ASSEMBLY
Refer to INSTALLATION [11/2016 - ]
- INSTALL AIR SURGE TANK TO INTAKE MANIFOLD GASKET
Refer to PROCEDURE - Step 15
- INSTALL INTAKE AIR SURGE TANK ASSEMBLY
Refer to PROCEDURE - Step 16
- CONNECT PURGE VALVE (PURGE VSV)
Refer to PROCEDURE - Step 17
- CONNECT VENTILATION HOSE
Refer to PROCEDURE - Step 18
- INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
Refer to INSTALLATION [11/2016 - ]
- INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 74
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing an ignition coil assembly and spark plug.
Refer to INITIALIZATION [11/2016 - ]
- Perform "Inspection After Repair" after replacing an ignition coil assembly and spark plug.