LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 109 (Engine Control System (2GR-FXS) - Service Information - (Hybrid)) >> Engine Coolant Temperature Sensor >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. DRAIN ENGINE COOLANT (for Engine) 

    Refer to PROCEDURE - Step 1

  2. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 22

  3. REMOVE RADIATOR SIDE DEFLECTOR SEAL LH 

    Refer to PROCEDURE - Step 1

  4. REMOVE RADIATOR SIDE SEAL RH 

    Refer to PROCEDURE - Step 2

  5. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 3

  6. REMOVE INLET AIR CLEANER ASSEMBLY 

    See step  5

  7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
      GTY692774Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the clip and engine coolant temperature sensor from the water outlet.
      GTY692775Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the engine coolant temperature sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals