LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE Plus >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Pre-Collision System Warning Buzzer (Service Information) (Except Hybrid) >> Pre-Collision System Warning Buzzer >> Removal [10/2015 - ] >> Procedure

Removal [10/2015 - ]: Procedure

  1. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 1

  2. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 4

  3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 5

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 11

  5. REMOVE INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 12

  6. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 13

  7. REMOVE LOWER NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 14

  8. REMOVE SKID CONTROL BUZZER ASSEMBLY 
    NOTE:

    If the skid control buzzer assembly has been struck or dropped, replace it with a new one.

    1. Using a clip remover, disengage the clamp.
      GTY378889Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector to remove the skid control buzzer assembly.
scientia non olet · About LEMON Manuals