LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> 4Runner TRD Pro >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case (VF2BM) - Service Information) >> 4WD Control Ecu >> Removal [08/2015 - 08/2019] >> Procedure

Removal [08/2015 - 08/2019]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH 

    Refer to PROCEDURE - Step 2

  2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH 

    Refer to PROCEDURE - Step 6

  3. REMOVE COWL SIDE TRIM BOARD RH 

    Refer to PROCEDURE - Step 8

  4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 21

  5. REMOVE LOWER INSTRUMENT COVER LH 

    Refer to PROCEDURE - Step 22

  6. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY 

    Refer to PROCEDURE - Step 8

  7. REMOVE INSTRUMENT PANEL BOX DOOR COVER 

    Refer to PROCEDURE - Step 24

  8. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  9. REMOVE FOUR WHEEL DRIVE CONTROL ECU 
    GTY726571Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the 2 connectors.
    2. Remove the bolt and four wheel drive control ECU.
scientia non olet · About LEMON Manuals