LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> 4Runner TRD Pro >> Repair and Diagnosis >> Electrical >> Gauges >> Meter / Gauge / Display - Service Information >> Accessory Meter >> Installation [08/2015 - 08/2019] >> Procedure

Installation [08/2015 - 08/2019]: Procedure

  1. INSTALL ACCESSORY METER ASSEMBLY 
    1. Connect the connector.
    2. Install the accessory meter assembly with the 2 screws.
  2. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKETS (for Navigation Receiver Type) 

    Refer to PROCEDURE - Step 5

  3. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS (for Radio and Display Type) 

    Refer to PROCEDURE - Step 4

  4. INSTALL HEATER CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 1

  5. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH 

    Refer to PROCEDURE - Step 3

  6. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH 

    Refer to PROCEDURE - Step 8

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] ).

scientia non olet · About LEMON Manuals