LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System (Service Information) (Except Hybrid) >> Navigation Receiver >> Removal [10/2015 - ] >> Procedure

Removal [10/2015 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Refer to PRECAUTION [12/2012 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [10/2015 - 08/2016] Refer to INITIALIZATION [08/2016 - ]

  3. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 4

  4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 5

  5. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 6

  6. REMOVE TELLTALE LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 4

  7. REMOVE NAVIGATION RECEIVER ASSEMBLY 
    1. Remove the 4 bolts.
      GTY597132Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the 4 clips and remove the navigation receiver assembly with bracket.
    3. Disconnect each connector.
  8. REMOVE WIRE HARNESS 

    Refer to PROCEDURE - Step 4

  9. REMOVE NO. 1 RADIO BRACKET 
    1. Remove the 5 screws and No. 1 radio bracket.
      GTY597131Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE NO. 2 RADIO BRACKET 
    GTY610620Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 5 screws and No. 2 radio bracket.
  11. REMOVE STEREO COMPONENT TUNER ASSEMBLY 

    Refer to PROCEDURE - Step 7

scientia non olet · About LEMON Manuals